|
|
Name: |
HEATER |
Introduction: |
¡¡
Widely used by plastic processing industry now,because of the huge impact on the clinate condition,the hygroscopic materials of NY10,PC,PET,etc have been provedthat it is unuseful to adopt the traditional hot air drying system to effectually reduce the humidity rate. Before the molding,the hygroscopic materials must use the drying air with high-stability low dew-point(at least-32¡æ)and match the proper drying temperat ure to ensure the humidity rate can be reduced under 0.02%.once this term can be achieved the molding products would exhibit their best physics feature and surface luminosity.The efficient dehumidified dryingmachine,besause it"s airtight circle system and drying air white a low point down to-50¡æ can impel pisession of shrink stripe and dent.
SPECIFICATION:
Noise testing condition:Without load,surveying noise decibel value within one meter The noise decibel valuewill continue to be improved. Just only forreference,none informed of any change
DRYING CAPACITY COMPARISON FORM:
Remark:1.Use alone drying hopper capacity;2.At 20¡æ air temperature and 65% relative humidity,moisture content under0.02% after
drying;3.Use efficient blower power.None inform of the change of the products size
|
Hot: |
¡¡894 |
|
|
|
